For experts: (From My-spread Forum)
Fishing approx 600 m of 2-3/8 Tubing we use as a salt dilution system in Algeria. The fish is roughly broken in two. The fish was caught and retrieved to surface where low and behold we have both strings, currently secured with clamps and slips. Well is stable on trip tank and our well control would be shear rams only. No gas or hydrocarbons at surface the pipe is corroded and clean of oil residue.
Currently thinking our best method of cutting this tubing without dropping the fish back in the hole.

Current situation: (2) strings of 2-3/8” Tubing secured with slips and clamps through the rig floor

Fish DATA:
2-3/8 4.6# 13% Cr Tubing
Length approx. 600m
The fish was tagged approx. 339m deeper than expected TOF.
Assume that the each fish is ~300m.
Both strings recovered through the rig floor (see photos)

What should be the plan?
https://bit.ly/3GkpkMq